หน้าแรก ดูโปรเจกต์ทั้งหมด
Expert

โปรเจกต์ Flashlight Controller

Flashlight controller สำหรับ 3 LED (White, Red, Green) มี 6 modes + พร้อมระบบ charging ด้วย solar panel โดยมีการกินไฟช่วง Power Off < 1mAmp

โปรเจกต์ Flashlight Controller
#Lights & LEDs

อุปกรณ์ที่ต้องใช้

เครื่องมือและเครื่องจักร

1x Arduino Nano R3
🔍 ค้นหา
1x Soldering iron (generic)
🔍 ค้นหา
3x LED (generic)
🔍 ค้นหา

รายละเอียดและวิธีทำ

Flash Light Controller, White LED, and navigation (red, green) and charging with Solar Panel.

6 modes, (work in progress)

  • Mcu atmega328P 3.3v
  • LiPo battery
  • 2n7000
  • Red LED 80ma
  • Green LED 80ma
  • White LED 100ma
  • pb switch
  • Shockley diode
  • few resistor
  • solar cell 5 volts 120 mamps

You will need to remove the Arduino power LED and the voltage regulator in order to minimize the power consumption. Mode: press and hold, wait for the green led flash the appropriate number and release.

  • Flash and release: Green/Red LED flashing every 1 sec (small boat navigation)
  • Flash and release: White LED 10%
  • Press and hold: set Level 10-100%. Off in 60 min
  • Press and release: Auto Off, slowly dimming down Off in 60 min, nightlights mode
  • Flash and release:release SOS
  • Flash release: RED 20% - Auto Off with Sun. Release

Press and release 100%. Off in 60 min

  • Flash and release: White Strobe 100%, every 2 sec, off with sun, on with the night release
  • Flash and release: Battery Level 1 to 10 flash (10-100%) release, auto off

And more... (any idea is welcome). Any time you can push the switch for turn off the (sleep mode).

📥 ไฟล์ดาวน์โหลด

Code

🔒 ปลดล็อก Code

สนับสนุนเพื่อรับ Source Code หรือแอปพลิเคชันสำหรับโปรเจกต์นี้

รหัสอ้างอิงโปรเจกต์: flashlight-controller-94fff6
1499 บาท
PromptPay QR Code